These updates are ONLY for users of easyDnc v1, easyDncXP, DncVista, and easyDnc 4.0
easyDnc 4.0 DOES NOT upgrade or replace any version of Dnc Remo
Remo users visit the 'Remo' website
If you already have an earlier version (2.x or 3.x) then the 'full upgrade' does not remove or make any changes to earlier versions so you can install 4.0 and then go back to the earlier version if you wish.
4.0 will detect any settings from earlier versions so you won't need to re-configure everything again.
Improvements to this version (4.0)
- 4.0a Improved installer/compatibility with Windows Vista
- 4.0d Additional line/block based Ack/Nak protocol included as a FlowControl option for CNC using the NEE PNC controls such as Denford Triac.
- 4.0f Added a 'PNC' mode (rather than a simple flow control option as in previous versions)
- 4.0h Improved 'PortScan'.
- 4.0i Fixes the "SpaceBar-Causes-a-Restart" problem.
Users of easyDnc 4.0a or above. - Quick Update to 4.0i
Users of easyDnc 3.0 or below. - Full upgrade to 4.0
Also use the full 4.0 upgrade if you're migrating/changing your computer or if you're upgrading your computer to Windows Vista. You can then come back to this page to check for quick updates.
- In case you haven't notice, we operate a Support Forum where you can ask questions and make suggestions for improving the product.
|
